 |
Matronics Email Lists
Web Forum Interface to the Matronics Email Lists
|
| View previous topic :: View next topic |
| Author |
Message |
ricksked(at)earthlink.net
Guest
|
 Posted: Thu Jan 05, 2006 11:42 am Post subject: flap-aileron trailing edge alignment |
 |
|
Jay,
I thought the same thing and figured out the flap was not fully retracted. See if the top skin or something else is causing the flap not to fully seat against the rear spar. It was only a very small amount to completely seat and then it was fine.
Rick S.
40185
Fuselage
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
| Back to top |
|
 |
jhasbrouck(at)woh.rr.com
Guest
|
| Posted: Thu Jan 05, 2006 3:01 pm Post subject: flap-aileron trailing edge alignment |
|
|
Jay,
As an aside, my Piper Arrow was much the same way. Ailerons and flap
trailing edges did not align with one side being farther off the the other.
Asked an IA about it and got the usual "they're all that way" response.
After comparing the -10 construction to the factory built Arrow I have
confidence in the strenght of the -10 airframe.....john
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
| Back to top |
|
|
LessDragProd(at)aol.com
Guest
|
| Posted: Thu Jan 05, 2006 8:45 pm Post subject: flap-aileron trailing edge alignment |
|
|
Per the Piper book, the Arrow uses the flaps to trim for roll.� Been there, done that.
�
Regards,
Jim Ayers
�
In a message dated 01/05/2006 3:03:00 PM Pacific Standard Time, jhasbrouck(at)woh.rr.com writes:
Jay,
� �� As an aside, my Piper Arrow was much the same way.� Ailerons and flap
trailing edges did not align with one side being farther off the the other.
Asked an IA about it and got the usual "they're all that way" response.
After comparing the -10 construction to the factory built Arrow I have
confidence in the strenght of the -10 airframe.....john
|
| | - The Matronics RV10-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?RV10-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
