kitfox(at)mcn.org
Guest
|
 Posted: Fri Dec 03, 2021 9:54 am Post subject: kitfox IV speedster jury strut questionkitfox IV speedster |
 |
|
Good Jack,
My struts are held in by adel clamps too. Still working well after 29 years.
Cheers,
Kirby
From: owner-kitfox-list-server(at)matronics.com <owner-kitfox-list-server(at)matronics.com> On Behalf Of Jack Bell
Sent: Thursday, December 2, 2021 6:48 PM
To: kitfox-list(at)matronics.com
Subject: Re: kitfox IV speedster jury strut questionkitfox IV speedster jury strut question
Thanks for the response. I think I have a way to make them fit, have some 1" adel clamps on order to fit to the lift struts. If they were the round jury struts, I could "tweak" them into shape, but these are streamlined, and powder coated to boot, so I have to make the plane fit them, and the supplied clamps, don't. I did find the lift struts were not quite straight, and that helps a bit. There's always something else to work on while parts are on their way!
Jack
Austin, TX
Avid Catalina N92KL (flying)
Osprey 2 N52JB (project on hold)
Kitfox IV speedster (project underway)
| Quote: | > | Quote: | | Hi Jack I built my Kitfox 3 with 4 wings in 1993. The jury strut fittings were a little off too. I think if the don't push or pull the wing braces you are ok. Cheers, Kirby Cramer Kitfox 4 NSI Subaru, N45KC Vans RV7A O-360, N445KC FAA Experimental Aircraft Repairman EAA Life Member I built my Kitfox 3 with 4 wings in 1993. The jury strut fittings were a little |
0 | Quote: | | I built my Kitfox 3 with 4 wings in 1993. The jury strut fittings were a little |
1
|
| | - The Matronics Kitfox-List Email Forum - | | | Use the List Feature Navigator to browse the many List utilities available such as the Email Subscriptions page, Archive Search & Download, 7-Day Browse, Chat, FAQ, Photoshare, and much more:
http://www.matronics.com/Navigator?Kitfox-List |
|
|
|
Get Email Distribution Too!
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
